tensile heatdistortion

中文翻译拉伸热变温度

同义词释义

    1)tensile heat-distortion,拉伸热变温度2)drawing temperature,拉伸温度3)stretching temperature,拉伸温度4)isothermal hot tensile test,恒温热拉伸5)tensile heat destortion,拉伸热畸变6)high temperature tension,高温拉伸变形

用法例句

    The results showed the uneveness in thickness of film, drawing temperature, pressure of both roller and infrared heater were main influence factors.

    结果表明:薄膜厚度不均、拉伸温度、压辊和红外加热器压力不均及安装检修不当是主要影响因素,通过调整检查可以减少“脱夹”的产生。

    The results show that stretching ratio,stretching temperature,casting conditions and APC system greatly influence the uniformity of film profile.

    结果表明,不同拉伸比、拉伸温度、铸片条件及APC系统的控制方式对厚度偏差影响较大。

    The transversely stretching temperature and rate have effect on the uniformity of PTFE membrane.

    横向拉伸温度和速率均影响薄膜均匀性,温度越高,厚度越薄,孔径越大。

    Steel Group has been studied by means of isothermal hot tensile test.

    通过恒温热拉伸的方法研究了太钢生产的00Cr22Ni5Mo3N双相不锈钢的超塑性行为,其中重点研究了该材料的低温超塑性。

    test method for tensile heat distortion temperature of plastic sheeting

    塑料板材的拉伸温度变化测定法

    Influence of Secondary Stretching Temperature on Configuration Change of Microvoids in Polyacylonitrile-based Precursor Fibres

    二次拉伸温度对PAN原丝中微孔洞形貌变化的影响

    The results of the tensile test indicate that the composite exhibit relatively high strength both at room temperature and high temperature.

    拉伸试验结果表明,该种复合材料具有较高的室温和高温拉伸强度。

    Tensile Strength of C/Al Composites at High Temprature

    碳(石墨)/铝复合材料的高温拉伸强度

    Mechanical behavior of PMMA under different temperatures and strain rates

    不同温度和应变率下PMMA拉伸性能

    Research on Temperature Control System of Heat Preservation in Bidirectional Pull Machine;

    双向拉伸机保温腔温度控制系统的研究

    Design on Temperature Control System of Heat Preservation in Bidirectional Pull Machine;

    双向拉伸机保温腔温度控制系统的设计

    At the same temperature, the as-cast lead brass has the finer prolongation at the higher velocity.

    在温度相同条件下,在较高的拉伸速度下获得了大伸长率。

    Numerical Simulation of Temperature Dependence of Tensile Mechanical Properties for Single Graphene Sheet

    石墨烯拉伸力学性能温度相关性的数值模拟

    Tensile Properties of Twist Low Angle Boundary of DD6 Single Crystal Superalloy

    DD6单晶高温合金扭转小角度晶界的拉伸性能

    Constitutive equations of high strength aluminum alloy sheet 7B04-T6 under warm tension

    高强度铝合金7B04-T6板材温拉伸本构方程

    Vulcanized rubber--Determination of tensile strength and ultimate elongation at high temperatures

    GB/T6037-1985硫化橡胶高温拉伸强度和扯断伸长率的测定

    Effect of Annealing Temperature on Microstructure and Tensile Properties of Ti_3Al Alloy Hot-Rolled Sheets

    退火温度对Ti_3Al合金热轧板材微观组织和室温拉伸性能的影响

    Special Drawing Methods That Could Improved Drawing Deformation Degree

    能提高拉伸变形程度的特殊拉伸方法

    Constitutive Description of Temperature and Strain Rate Dependent Tensile Behaviors of Solder;

    焊锡钎料温度与应变率相关拉伸性能的本构描述

    Molecular dynamics simulation of the bicrystal copper nanowires under the uniaxial tensile strain:Temperature and grain boundary effect

    温度对双晶铜纳米线拉伸行为的分子动力学模拟研究

    Effect of Temperature on the Dynamic Tensile Behavior and Fracture Mechanism of Mg-10Gd-2Y-0.5Zr Alloy

    温度对Mg-10Gd-2Y-0.5Zr合金动态拉伸行为及断裂机理的影响

    Tensile Fracture Tests of a 980MPa High Strength Steel at Various Temperatures

    一种新型980MPa高强钢在不同温度下的拉伸断裂试验