birectangular

用法例句

Process research on preparation of aluminum alloy die-forging blank with right-angled bends on both sides

两侧带直角弯的铝合金模锻件坯料制备工艺研究

Process research on preparation of aluminum alloy die-forging blank with right-angled bends on both sides

两侧带直角弯的铝合金模锻件坯料制备工艺研究

With some angle between axes of pass and rolls, the flexture either on plane or on sides can straightened at one time.

孔型轴线与矫直辊轴线成一定的倾角，使得扁钢的平面弯曲及侧面弯曲一次性被矫直。

The outer point on either side of the lower jaw at which the jawbone angles upward.

下颌角点下颚两侧的突出点，在这此下颚骨向上弯曲

(3)The bilateral margin of lesions were straight, and the lesions appeared square or triangular in shape.

(3 )病灶两侧缘平直 ,病灶呈方形或三角形 ;

Up to a certain sum of the interior angles on one side of the transversal the two lines might indeed meet.

截线一侧两内角到达一定的和数，两直线可能一定相交。

Without beating around the bush

直截了当，不拐弯抹角

a strip of metal with ends bent at right angles; used to hold masonry together.

两端弯成直角的一条金属；用以固结石造物或木料。

pipe bend with female thread

两头带阴螺纹的弯头

Large deformation bands were observed at each side of the crack.

实验结果表明：在裂尖两侧存在与裂纹方向夹角约为50°大变形带。

Guide edges: Edges of the sheet that is fed to the front and side guides respectively.The two guide edge of the sheet must be square.

纸规边:分别接触前纸规和侧纸规的纸边。纸的两 个纸规边要成直角。

Direct Current System and Remote Backup Protection for Phase-to-phase Faults at the Angle-connected Side of Transformers;

直流系统及变压器角接侧两相故障远后备保护的研究

Now, start out standing erect with both hands at your sides.

现在，先站直，两手垂直于身体两侧。

three-diameter ells with tangents

带切线直管段的三倍直径弯头

All feet first entries shall be executed with the arms close to the Body and no bending at the elbows.

脚先入水时,两臂应紧贴身体两侧,手肘不能弯曲。

There appears to be a small region on either side of the body's median plane( which bisects the body vertically) where people have trouble.

这似乎显示，人体正中面（人体垂直分割成左右两半）两侧都有一小区死角。

The study of the efficacy of ventral manipulation for correction of congenital chordee without hypospadias

先天性阴茎下弯腹侧矫直技术的有效性观察

band of position

船位误差带位置线两侧)船位误差带

Effect of Entrance/exit Leveler Roller' intermesh to Plate Flatness

辊式矫直过程中板带弯曲挠度的确定